Goto Section: 24.229 | 24.235 | Table of Contents

FCC 24.232
Revised as of October 1, 2005
Goto Year:2004 | 2006
Sec.  24.232   Power and antenna height limits.

   (a) Base stations are limited to 1640 watts peak equivalent isotropically
   radiated power (EIRP) with an antenna height up to 300 meters HAAT, except
   as described in paragraph (b) of this section. See  Sec. 24.53 for HAAT
   calculation method. Base station antenna heights may exceed 300 meters with
   a corresponding reduction in power; see Table 1 of this section. In no case
   may the peak output power of a base station transmitter exceed 100 watts.
   The service area boundary limit and microwave protection criteria specified
   in  Sec. 24.236 and  Sec. 24.237 apply.

 Table 1._Reduced Power for Base Station Antenna Heights Over 300 Meters
------------------------------------------------------------------------
                                                                Maximum
                        HAAT in meters                            EIRP
                                                                 watts
------------------------------------------------------------------------
[le]300......................................................       1640
[le]500......................................................       1070
[le]1000.....................................................        490
[le]1500.....................................................        270
[le]2000.....................................................        160
------------------------------------------------------------------------

   (b) Base stations that are located in counties with population densities of
   100 persons or fewer per square mile, based upon the most recently available
   population statistics from the Bureau of the Census, are limited to 3280
   watts peak equivalent isotropically radiated power (EIRP) with an antenna
   height up to 300 meters HAAT; See  Sec. 24.53 for HAAT calculation method. Base
   station antenna heights may exceed 300 meters with a corresponding reduction
   in power; see Table 2 of this section. In no case may the peak output power
   of a base station transmitter exceed 200 watts. The service area boundary
   limit and microwave protection criteria specified in  Sec. 24.236 and  Sec. 24.237
   apply. Operation under this paragraph must be coordinated in advance with
   all PCS licensees within 120 kilometers (75 miles) of the base station and
   is limited to base stations located more than 120 kilometers (75 miles) from
   the Canadian border and more than 75 kilometers (45 miles) from the Mexican
   border.

 Table 2._Reduced Power for Base Station Antenna Heights Over 300 Meters
------------------------------------------------------------------------
                                                                Maximum
                        HAAT in meters                            EIRP
                                                                 watts
------------------------------------------------------------------------
[le]300......................................................       3280
[le]500......................................................       2140
[le]1000.....................................................        980
[le]1500.....................................................        540
[le]2000.....................................................        320
------------------------------------------------------------------------

   (c) Mobile/portable stations are limited to 2 watts EIRP peak power and the
   equipment must employ means to limit the power to the minimum necessary for
   successful communications.

   (d) Peak transmit power must be measured over any interval of continuous
   transmission using instrumentation calibrated in terms of an rms-equivalent
   voltage. The measurement results shall be properly adjusted for any
   instrument limitations, such as detector response times, limited resolution
   bandwidth capability when compared to the emission bandwidth, sensitivity,
   etc., so as to obtain a true peak measurement for the emission in question
   over the full bandwidth of the channel.

   [ 69 FR 75171 , Dec. 15, 2004]


Goto Section: 24.229 | 24.235

Goto Year: 2004 | 2006
CiteFind - See documents on FCC website that cite this rule

Want to support this service?
Thanks!

Report errors in this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public