Goto Section: 11.51 | 11.53 | Table of Contents
FCC 11.52
Revised as of October 1, 2019
Goto Year:2018 |
2020
§ 11.52 EAS code and Attention Signal Monitoring requirements.
(a) EAS Participants must be capable of receiving the Attention Signal
required by § 11.31(a)(2) and emergency messages of other broadcast
stations during their hours of operation. EAS Participants must install
and operate during their hours of operation, equipment that is capable
of receiving and decoding, either automatically or manually, the EAS
header codes, emergency messages and EOM code, and which complies with
the requirements in § 11.56.
Note to paragraph (a): The two-tone Attention Signal will not be used
to actuate two-tone decoders but will be used as an aural alert signal.
(b) If manual interrupt is used as authorized in § 11.51(m)(2), decoders
must be located so that operators at their normal duty stations can be
alerted immediately when EAS messages are received.
(c) EAS Participants that are co-owned and co-located with a combined
studio or control facility (such as an AM and FM licensed to the same
entity and at the same location or a cable headend serving more than
one system) may comply with the EAS monitoring requirements contained
in this section for the combined station or system with one EAS
Decoder. The requirements of § 11.33 must be met by the combined
facility.
(d) EAS Participants must comply with the following monitoring
requirements:
(1) With respect to monitoring for EAS messages that are formatted in
accordance with the EAS Protocol, EAS Participants must monitor two EAS
sources. The monitoring assignments of each broadcast station and cable
system and wireless cable system are specified in the State EAS Plan
and FCC Mapbook. They are developed in accordance with FCC monitoring
priorities.
(2) With respect to monitoring EAS messages formatted in accordance
with the specifications set forth in § 11.56(a)(2), EAS Participants'
EAS equipment must interface with the Federal Emergency Management
Agency's Integrated Public Alert and Warning System (IPAWS) to enable
(whether through “pull” interface technologies, such as Really Simple
Syndication (RSS) and Atom Syndication Format (ATOM), or “push”
interface technologies, such as instant messaging and email) the
distribution of Common Alert Protocol (CAP)-formatted alert messages
from the IPAWS system to EAS Participants' EAS equipment.
(3) If the required EAS message sources cannot be received, alternate
arrangements or a waiver may be obtained by written request to the
Chief, Public Safety and Homeland Security Bureau. In an emergency, a
waiver may be issued over the telephone with a follow up letter to
confirm temporary or permanent reassignment.
(4) The management of EAS Participants shall determine which header
codes will automatically interrupt their programming for State and
Local Area emergency situations affecting their audiences.
(e) EAS Participants are required to interrupt normal programming
either automatically or manually when they receive an EAS message in
which the header code contains the Event codes for Emergency Action
Notification (EAN), the National Periodic Test (NPT), or the Required
Monthly Test (RMT) for their State or State/county location.
(1) Automatic interrupt of programming is required when facilities are
unattended. Automatic operation must provide a permanent record of the
EAS message that contains at a minimum the following information:
Originator, Event, Location and valid time period of the message.
(2) Manual interrupt of programming and transmission of EAS messages
may be used. EAS messages with the EAN Event code, or the NPT Event
code in the case of a nationwide test of the EAS, must be transmitted
immediately; Monthly EAS test messages must be transmitted within 60
minutes. All actions must be logged and recorded as specified in
§ § 11.35(a) and 11.54(a)(3). Decoders must be programmed for the EAN
Event header code and the RMT and RWT Event header codes (for required
monthly and weekly tests), with the appropriate accompanying State and
State/county location codes.
[ 70 FR 71036 , Nov. 25, 2005, as amended at 77 FR 16705 , Mar. 22, 2012;
80 FR 37176 , June 30, 2015; 83 FR 37759 , Aug. 2, 2018]
return arrow Back to Top
Goto Section: 11.51 | 11.53
Goto Year: 2018 |
2020
CiteFind - See documents on FCC website that
cite this rule
Want to support this service?
Thanks!
Report errors in
this rule. Since these rules are converted to HTML by machine, it's possible errors have been made. Please
help us improve these rules by clicking the Report FCC Rule Errors link to report an error.
hallikainen.com
Helping make public information public